L2-CC (Box of 24)

On Hand Qty: 0
125 will arrive on 2021-04-02

    432.00 432.00 432.0 USD

    864.00

    This combination does not exist.

    Add to Cart

    Constant Current Driver, Dimmable, 30W, Output: 75/150/300/600mA, 9-60Vdc



    The L2-CC driver converts main PDM power into constant current regulated power.  It plugs into a Power Distribution Module (PDM) Socket and sends power to one or more LEDs attached to the associated RJ45 Port.  This is used for LED fixtures requiring constant current where a driver or regulator is not inside the bulb.  This module does not require an L2-APR.  Its output level is controlled by a Channel Zone Controller like an L2-DM, L2-SW, or L2-CH16.  The L2-CC driver automatically adjusts its power output to maintain accurate current regardless of the length of Cat5/6 attached. This ensures consistent fixture intensity.  Small LED lights can be connected in Series.  LEDs in series must have an identical Current requirement of each other and the L2-CC current DIP switches must be set to match the LED current requirement.  L2-CC are full range buck-boost drivers so the total attached LED voltage can be anywhere from the minimum to the maximum total voltage.  Choose from 75mA, 150mA, 300mA, or 600mA current settings.

    POWER
    Power output20W (12-24VDC supply)
    30W (40-65VDC supply) (recommended)
    Output currentSelectable: 75mA, 150mA, 300mA, 600mA
    LED output voltage9 - 65VDC
    PDM input voltage12 - 56VDC
    Regulator frequency250kHz
    Efficiency88%
    Absolute maximum voltage60VDC
    ZONE CHANNEL INPUT
    Control channel signal typeControlled by 0-5VDC, PWM dimming
    Channel frequency122-2000Hz
    PHYSICAL/ENVIRONMENTAL
    Dimensions1.65 x 0.95x 0.23in (42 x 24 x 6mm)
    Operating temperature+32°F to +122°F (0°C to +50°C)
    Operating humidity5% to 95% Non-condensing
    EnvironmentalRoHS
    Safety certificationsANSI/UL 2108, UL/CSA 60950-1, CAN/CSA C22.2#250.13, CSA C22.2#9.0, CSA C22.2#223, FCC, CE
    RatingDry Rated
    WARRANTY
    Duration5 Years

    Select the current setting to match the fixtures attached to the port.  See the labels on the fixtures for the current requirements.  If the LED is higher than one of the settings, use the setting below the LED fixture current.  For example: if the fixture current is 400mA, choose the 300mA setting (also the default). 

    L2-CC DIP Current Settings

    SW1

    SW2

    CURRENT OUTPUT

    OFF

    OFF

    600mA

    OFF

    ON

    300mA (default)

    ON

    OFF

    150mA

    ON

    ON

    75mA

    This is a preview of the recently viewed products by the user.
    Once the user has seen at least one product this snippet will be visible.

    Recently viewed Products